CAMERA OPERATING SOFTWARE HZC-MSCN1 USER’S GUIDE [English] 1st Edition
Overview The HZC-MSCN1 is optional software for the CNA-1 Camera Control Network Adaptor. Installing this software allows you to control multiple cameras from one CNA-1 by expanding the Gateway function of the CNA1. Camera selecting function You can use the camera selecting command with the simple protocol of the Gateway function by installing the HZC-MSCN1 to the CNA-1 and setting the Gateway Emulation mode of the CNA-1 to MSU. You can then select the camera, and control it by using the simple protocol.
Examples of System Configurations Controlling multiple Sony cameras from the expanded panel device Note The expanded panel device needs to be compatible with the protocol that is supplied by the CNA-1. Camera head CCU MCS Mode: Client Camera head CCU MCS Mode: Client Camera head CCU MCS Mode: Client Expanded panel device CNA-1 Network hub MSU MCS Mode: Master : LAN cable CNA-1 setup For details about the setting items, see “Menu operation” on the CNA-1 Operation Manual.
Installation Performing installation 1 Display the setup menu of the CNA-1. The setup menu of the CNA-1 can be operated from a PC by using the Web browser. For details, see “Menu operation” in the CNA-1 Operation Manual. 2 Display the System page. 3 Input the 16-digit install key to the “Install Key” input box of “6. Install optional software.” 4 Click the “Install” button. Check the installation results 4 1 Display the Status page.
Setting the Gateway Function To use the camera selecting function 1 Display the CNS page. 2 Set the Gateway function to “Enable.” For details, see “Menu operation” in the CNA-1 Operation Manual. 3 Set “Emulation Mode” of “2. Gateway Configuration” to “MSU.” 4 Set the Device No. Device No. should be set different from any other MSU number on the network. For details about the camera selecting function, contact a Sony service representative.
Sony Corporation HZC-MSCN1 (WW) 4-535-259-11(1) © 2013
