User Manual

62
• The shutter value may not be displayed
correctly when recording in Super Slow Motion
if [SHUTTER DISPLAY] is set to [DEGREE]
(p. 115).
• Available only when the AUTO/MANUAL
switch is set to MANUAL. Note that iris, ISO
sensitivity/gain, and shutter speed are fixed to
manual.
• When the [FRAME RATE] is set to [960]
([1000]), the image displayed and recorded
shifts approximately 1.35 times toward the
telephoto side.
• When the [FRAME RATE] is set to [480] or
[960] ([500] or [1000]), the picture will be
slightly degraded relative to normal shooting.
• Changing the ISO sensitivity/gain, shutter
speed, or white balance will cause degradation
of the image on the LCD screen, but the camera
settings in force when shooting ends are applied
to the recorded image. For details about
displaying camera data, see page 66.
• To change the frame rate setting, first stop
recording.
• The timecode is recorded in [REC RUN] mode
(p. 118).
• Super Slow Motion mode is automatically
canceled when the camcorder is turned off, but
the [FRAME RATE] setting is retained.
• Flicker correction has no effect.
• You cannot record sound.
• The auto focus function is not supported.
• Shutter speeds slower than the frame rate cannot
be selected.
• Super Slow Motion recording is not supported
when the file format is XAVC S 4K.
• For details about Super Slow Motion
limitations, see “Slow & Quick Motion and
Super Slow Motion recording limitations”
(p. 146).
You can review the most recently recorded
scene on the LCD screen.
You can assign this function to an ASSIGN
button.
For details about function assignment
operation to an ASSIGN button, see
“Assigning functions to the ASSIGN
buttons” (p. 63).
After you stop recording, press the
ASSIGN button to which [LAST
SCENE REVIEW] is assigned.
The camcorder plays from the start to the
end of the most recently recorded scene,
then returns to standby mode.
To stop reviewing the last scene
Press the ASSIGN button to which [LAST
SCENE REVIEW] is assigned during
playback. The camcorder returns to standby
mode.
b Note
• If you edit the movie or remove the recording
media after you stop recording, the Last Scene
Review function may not work correctly.
Reviewing the most recently
recorded scene (Last Scene
Review)
Useful functions (Continued)