User Manual

155
Additional Information
x To clean the LCD screen
The LCD screen is covered with a coating. The
coating may be peeled off by scratching or
rubbing. Maintain the LCD screen as follows.
• Wipe fingerprints or hand cream off the LCD
screen as soon as possible, as they may cause
the coating to peel off.
• If you rub the LCD screen hard, even with a
tissue, the coating may be damaged.
• Before wiping the LCD screen, blow dust or
sand off with a dust blower, etc.
• Wipe dirt off the LCD screen with a clean, soft
cloth, such as an eye glass cleaning cloth, etc.
x To adjust the touch panel
(CALIBRATION)
The buttons on the touch panel may not
work correctly.
If this happens, follow the procedure below. It is
recommended that you connect your camcorder to
the wall outlet (wall socket) using the supplied
AC Adaptor during the operation.
1 Press the MENU button t select
(OTHERS) t [CALIBRATION] with
the v/V/b/B/SET button.
2 Touch “×” displayed on the LCD screen
with the corner of memory card or the
like 3 times.
b Notes
• If you did not press the right spot, try the
calibration again.
• Do not use a sharp-pointed object for
calibration. Doing so may damage the LCD
screen.
• You cannot perform the calibration when the
LCD screen is turned around, or facing up and
closed to the camcorder
x OLED panel display
The OLED panel may experience issues such as
screen burn-in or loss of brightness with normal
use over time.
This is not a malfunction.
Casing
• If the casing is soiled, clean the camcorder body
with a soft cloth lightly moistened with water,
and then wipe the casing with a dry soft cloth.
• Avoid the following to prevent damage to the
finish.
– Using chemicals such as thinner, benzine,
alcohol, chemical cloths, repellent, insecticide
and sunscreen.
– Handling with above substances on your
hands.
– Leaving the casing in contact with rubber or
vinyl objects for a long period of time.
Care and storage of the lens
• Wipe the surface of the lens clean with a soft
cloth in the following instances: when there are
fingerprints on the lens surface, in hot or humid
locations, and when the lens is exposed to salty
air such as at the seaside.
• Store in a well-ventilated location subject to
little dirt or dust.
• To prevent mold, periodically clean the lens as
described above.
Charging the pre-installed
rechargeable battery
Your camcorder has a pre-installed
rechargeable battery to retain the date, time,
and other settings even when the 1 (On/
Standby) button is set to the standby
position. The pre-installed rechargeable
battery is always charged while your
camcorder is connected to the wall outlet
(wall socket) via the AC Adaptor or while
the battery pack is attached. The
rechargeable battery will be fully
discharged in about 3 months if you do
not use your camcorder at all, with the AC
Adaptor not connected or battery pack not
attached. Use your camcorder after
charging the pre-installed rechargeable
battery.
However, even if the pre-installed
rechargeable battery is not charged, the
camcorder operation will not be affected as
long as you are not recording the date.
Continued ,