User Manual

4
US
This speaker system contains license-
exempt transmitter(s)/receiver(s) that
comply with Innovation, Science and
Economic Development Canada’s
license-exempt RSS(s). Operation is
subject to the following two conditions:
This speaker system complies with ISED
radiation exposure limits set forth for an
uncontrolled environment and meets
RSS-102 of the ISED radio frequency (RF)
Exposure rules. This speaker system
should be installed and operated
keeping the radiator at least 20 cm or
more away from person’s body.
5.15 - 5.35 GHz band is restricted to
indoor operations only.
Data transmission is always initiated by
software, which is the passed down
through the MAC, through the digital
and analog baseband, and finally to the
RF chip. Several special packets are
initiated by the MAC.
These are the only ways the digital
baseband portion will turn on the RF
transmitter, which it then turns off at the
end of the packet. Therefore, the
transmitter will be on only while one of
the aforementioned packets is being
transmitted. In other words, this device
automatically discontinue transmission
in case of either absence of information
to transmit or operational failure.
Caution for mounting the bar
speaker on a wall
Make sure to use the supplied
wall mounting brackets when
mounting the bar speaker on a
wall.
Make sure to use the supplied wall
mounting brackets when mounting the
bar speaker on a wall. Do not mount the
bar speaker on a wall directly. The
temperature inside the bar speaker rises
considerably, and it may cause damage
or malfunction.
(1) This speaker system may not cause
interference; and
(2) This speaker system must accept any
interference, including interference
that may cause undesired operation
of the speaker system.