Operating Instructions
Table Of Contents
- Getting Started
- Description and location of parts
- 1: Installing the speakers
- 2: Connecting the speakers
- 3: Connecting the audio/ video components
- 4: Connecting the antennas
- 5: Preparing the receiver and the remote
- 6: Calibrating the appropriate settings automatically (AUTO CALIBRATION)
- 7: Adjusting the speaker levels and balance (TEST TONE)
- Playback
- Amplifier Operations
- Enjoying Surround Sound
- Tuner Operations
- Control for HDMI
- Other Operations
- Using the Remote
- Additional Information
54
GB
Using the Control for
HDMI function for
“BRAVIA” Sync
To use “BRAVIA” Sync, set the Control for
HDMI function as explained below.
By connecting Sony components that are
compatible with the Control for HDMI
function with an HDMI cable (not supplied),
operation is simplified as follows:
• One-Touch Play: When you play back a
component such as a DVD/Blu-ray disc
player, the receiver and the TV are turned on
automatically and switched to the
appropriate HDMI input.
• System Audio Control: While watching TV,
you can select to output the sound from the
TV speaker or the speakers connected to the
receiver.
• System Power Off: When you turn off the
TV, the receiver and connected components
are also turned off simultaneously.
Control for HDMI is a mutual control function
standard used by HDMI CEC (Consumer
Electronics Control) for HDMI (High-
Definition Multimedia Interface).
The Control for HDMI function
does not work in the following
cases:
• When you connect the receiver to a
component which does not correspond with
Sony Control for HDMI function.
• When you connect the receiver and
components using other than HDMI
connection.
We recommend that you connect the receiver
to products featuring “BRAVIA” Sync.
Note
Depending on the connected component, the
Control for HDMI function may not work. Refer to
the operating instructions of the component.
Control for HDMI