Operating Instructions
Table Of Contents
- Getting Started
- Description and location of parts
- 1: Installing the speakers
- 2: Connecting the speakers
- 3: Connecting the audio/ video components
- 4: Connecting the antennas
- 5: Preparing the receiver and the remote
- 6: Calibrating the appropriate settings automatically (AUTO CALIBRATION)
- 7: Adjusting the speaker levels and balance (TEST TONE)
- Playback
- Amplifier Operations
- Enjoying Surround Sound
- Tuner Operations
- Control for HDMI
- Other Operations
- Using the Remote
- Additional Information
38
GB
a)
For details, refer to the page in the parentheses.
b)
The surround effect is not available for 2CH STEREO and A.F.D. mode.
c)
“AUDIO FOR HDMI” and “CONTROL FOR HDMI” scroll across the display, then “AUDIO” and
“CONTROL” appear respectively.
d)
When you set “CAL LOAD” in A. CAL menu to “LOAD YES”, the setting is displayed as x.xx m
(xx’xx”) and you can adjust the setting in 0.01 meter (1 inch) increment.
e)
After you select the setting, press to confirm the selection.
Menu
[Display]
Parameters
[Display]
Settings Initial setting
A. CAL
[8-A. CAL]
(page 30)
Auto calibration no/yes
a)e)
[AUTO CAL]
A.CAL NO, A.CAL YES A.CAL NO
Calibration load
a)d)
[CAL LOAD]
LOAD YES, LOAD NO LOAD YES