Operating Instructions
Table Of Contents
- Getting Started
- Description and location of parts
- 1: Installing speakers
- 2: Connecting speakers
- 3: Connecting the audio/ video components
- 4: Connecting the antennas
- 5: Preparing the receiver and the remote
- 6: Calibrating the appropriate settings automatically (AUTO CALIBRATION)
- 7: Adjusting the speaker levels and balance (TEST TONE)
- Playback
- Amplifier Operations
- Enjoying Surround Sound
- Tuner Operations
- Other Operations
- Using the Remote
- Additional Information
54
GB
D:\CANNES\SONY_HA\JOB 2007\HT-SS2000\IM_SS2000\Data_CEL\Data_GB\GB06OTH_HT-
SF2000-CEL.fm
masterpage: Left
[HT-SF2000/HT-SS2000]
3-210-806-11
(1)
Switching between
digital and analog audio
(IN MODE)
You can select the audio input mode setting
when you connect components to both digital
and analog audio input jacks on the receiver.
1 Press AMP MENU.
“1-LEVEL” appears on the display.
2 Press V/v repeatedly to select
“5-AUDIO”.
3 Press or b to enter the
menu.
4 Press V/v repeatedly to select
“IN MODE”.
5 Press or b to enter the
parameter.
6 Press V/v repeatedly to select
the audio input you want.
To return to the previous display
Press B.
Audio input modes
x AUTO IN
Gives priority to digital audio signals when
there are both digital and analog connections.
If there are no digital audio signals, analog
audio signals are selected.
x HDMI IN
Specifies the audio signals input to the HDMI
jack.
x COAX IN
Specifies the digital audio signals input to the
DIGITAL COAX IN jack.
x OPT IN
Specifies the digital audio signals input to the
DIGITAL OPT IN jack.
x ANALOG
Specifies the analog audio signals input to the
AUDIO IN (L/R) jacks.
Note
Some audio input modes may not be set up
depending on the input.
Other Operations