Operating Instructions
Table Of Contents
- Getting Started
- Description and location of parts
- 1: Installing speakers
- 2: Connecting speakers
- 3: Connecting the audio/ video components
- 4: Connecting the antennas
- 5: Preparing the receiver and the remote
- 6: Calibrating the appropriate settings automatically (AUTO CALIBRATION)
- 7: Adjusting the speaker levels and balance (TEST TONE)
- Playback
- Amplifier Operations
- Enjoying Surround Sound
- Tuner Operations
- Other Operations
- Using the Remote
- Additional Information
37
GB
D:\CANNES\SONY_HA\JOB 2007\HT-SS2000\IM_SS2000\Data_CEL\Data_GB\GB05AMP_HT-
SF2000-CEL.fm
masterpage: Right
[HT-SF2000/HT-SS2000]
3-210-806-11
(1)
Amplifier Operations
a)
For details, refer to the page in the parentheses.
b)
The surround effect is not available for 2CH STEREO and A.F.D. mode.
c)
When you select this parameter, the “HDMI” indicator flashes in the display.
d)
When you set “CAL LOAD” in A. CAL menu to “LOAD YES”, the setting is displayed as x.xx m
(xx’xx”) and you can adjust the setting in 0.01 meter (1 inch) increment.
e)
After you have select the setting, press to confirm the selection.
f)
The default setting for models of area code U, UC is “ft.” and for models of other area code is “m”.
Menu
[Display]
Parameters
[Display]
Settings Initial setting
A. CAL
[8-A. CAL]
(page 29)
Auto calibration on/off
a)e)
[AUTO CAL]
A.CAL YES, A.CAL NO A.CAL NO
Calibration load
a)d)
[CAL LOAD]
LOAD NO, LOAD YES LOAD YES