Operating Instructions
Table Of Contents
- Getting Started
- Description and location of parts
- 1: Installing speakers
- 2: Connecting speakers
- 3: Connecting the audio/ video components
- 4: Connecting the antennas
- 5: Preparing the receiver and the remote
- 6: Calibrating the appropriate settings automatically (AUTO CALIBRATION)
- 7: Adjusting the speaker levels and balance (TEST TONE)
- Playback
- Amplifier Operations
- Enjoying Surround Sound
- Tuner Operations
- Other Operations
- Using the Remote
- Additional Information
24
GB
D:\CANNES\SONY_HA\JOB 2007\HT-SS2000\IM_SS2000\Data_CEL\Data_GB\GB03CON_HT-
SF2000-CEL.fm
masterpage: Left
[HT-SF2000/HT-SS2000]
3-210-806-11
(1)
5: Preparing the receiver
and the remote
Connect the AC power cord to a wall outlet.
Before using the receiver for the first time,
initialize the receiver by performing the
following procedure. This procedure can also
be used to return settings you have made to
their factory defaults.
Be sure to use the buttons on the receiver for
this operation.
1 Press ?/1 to turn off the
receiver.
2 Hold down ?/1 for 5 seconds.
“CLEARING” appears on the display for
a while, then “CLEARED” appears.
The following items are reset to their
factory settings.
• All settings in the LEVEL, TONE,
SUR, TUNER, AUDIO, VIDEO,
SYSTEM and A. CAL menus.
• The sound field memorized for each
input and preset station.
• All sound field parameters.
• All preset stations.
• MASTER VOLUME is set to “VOL
MIN”.
• Input is set to “DVD”.
Connecting the AC power cord
CENTER SUBWOOFERSUR L
AC power cord
To the wall outlet
Performing initial setup
operations
AUTO CAL MIC
MUTING
MASTER VOLUME
SOUND FIELDPRESET TUNING
1,2