Help Guide (Web manual)

and then select [OK].
The HDD AUDIO PLAYER connects to the network and starts downloading the
new version of the software.
Installation will start automatically after downloading is complete.
You can confirm the progress status on the screen.
After the software update is complete, the HDD AUDIO PLAYER restarts
automatically.
Note
Do not turn the HDD AUDIO PLAYER off or disconnect the LAN cable during the
software update. This may cause a malfunction.
Select [Cancel] to cancel the software update while downloading the software.
If the software update fails, an update error screen appears and the HDD AUDIO
PLAYER may restart.
If you update the software during playback, the playback stops.
The power is automatically turned off.
If the [Auto Standby] function is set to [On], the HDD AUDIO PLAYER is
automatically turned off after it is not operated for approximately 20 minutes.
If the sleep timer function is set, the HDD AUDIO PLAYER is automatically turned
off when the specific time you set has elapsed.
If the top of the HDD AUDIO PLAYER is covered, the internal protector activates
and the HDD AUDIO PLAYER automatically turns off. Remove the object(s)
covering the upper panel of the HDD AUDIO PLAYER and turn the power on
again.
When the [Network Standby] function is set to [On], the HDD AUDIO PLAYER
automatically turns on when a music file transfer is performed by HAP Music
Transfer or the HDD Audio Remote application installed on your smartphone or
tablet. The HDD AUDIO PLAYER turns off automatically when the music files are
transferred and registered.