Help Guide

While recording is in progress, do not change the INPUT1 or INPUT2 switch settings.

Before connecting/disconnecting an external microphone or device to/from the INPUT1 or INPUT2 jack, be sure to set the

INPUT1 (LINE/MIC/MIC+48V) or INPUT2 (LINE/MIC/MIC+48V) switch to a position other than “MIC+48V.” Plugging/unplugging

the cable into/from the external microphone or device while the switch is set to “MIC+48V” may cause loud noise or a malfunction

of the device.

Before attaching/removing a microphone (sold separately) to/from the adaptor, be sure to set the INPUT1 (LINE/MIC/MIC+48V)

switch to a position other than “MIC+48V.” While the switch is set to “MIC+48V,” plugging/unplugging the cable into/from the

microphone may cause a loud noise or a malfunction of the microphone.

If there is noticeable noise coming from the jacks with no device connected to them, set the INPUT1 (LINE/MIC/MIC+48V) or

INPUT2 (LINE/MIC/MIC+48V) switch to “LINE.”

When the INPUT1 (LINE/MIC/MIC+48V) or INPUT2 (LINE/MIC/MIC+48V) switch is set to “LINE,” the standard input level is

locked to +4 dBu. The standard input level will not change according to the ATT switch setting.