Setup Guide

HTML Interface Configuration
Once power has been applied to the unit, an IP address must be assigned manually thru the EBS-
N100’s web interface.
All EBS-N100’s are shipped with a Static IP Address of 192.168.0.10. This IP address can be
changed as follow:
• Connect the EBS-N100 to a computer with the same sub-net (192.168.0.XXX)
• Start the computers browser and enter 192.168.0.10
• The EBS-N100’s main web page will appear; select the Configure tab and the following page
will appear
• Set the desired IP address, Subnet Mask, and Default Gateway and document below:
IP Address:
• Select Submit and Restart to reboot the unit for the new IP Address to take effect
Configuring the Unit
Before you begin using the EBS-N100, you must enter the display type and model to which it is
connected. The controls available in the user interface (EBS-N100 software) directly correspond to the