User's Manual

19
Changing the Settings on
the Transmitter
For details on menu operation, see “Basic menu
operations” on page 12.
You can change the settings on the transmitter that is
paired with this receiver using the RX1/2 menu or the
TX1/2 menu.
The following shows the US model display.
Group/channel setting (GP/CH)
This setting is set through the GP/CH indication of the
RX1/2 menu.
For details, see “Selecting the frequency band / group /
channel” on page 7.
Audio attenuator setting (ATT)
When the input of the transmitter is set to MIC, the value
of the attenuator can be changed.
The attenuator values that can be selected depend on the
transmitter function.
Low-cut filter setting (LCF)
The low-cut filter setting of the transmitter can be changed.
The frequency selection depends on the transmitter
function.
Lock function setting (LOCK)
This disables the transmitter main unit POWER button and
locks settings so they cannot be changed. Doing so
prevents users from accidentally turning off the power.
Settings can be changed via Cross Remote from the
receiver even if the transmitter LOCK function is enabled.
Power-saving setting (POWER SAVE)
To conserve power, this setting allows you to change the
transmitter to sleep mode using the wireless remote control
function.
When the transmitter changes to sleep mode, transmission
of the RF audio signal and metadata is stopped. For this
reason, “NO DATA” appears for all items in the TX1/2
menu, except for “SLEEP” in the POWER SAVE
indication.
Setting the audio input level (INPUT
LEVEL)
You can set the input level to the transmitter.
Transmission power setting (RF POWER)
You can change the transmission power of the transmitter.
Always perform pairing after changing the maximum RF
output power setting for a transmitter. If you fail to do so,
configuration of RF output power settings via the wireless
remote control function may become impossible.
For details on pairing, see “Pairing with a transmitter” on
page 17.
+48V power setting (+48V)
Turns the +48V on the transmitter on or off.
This function may not be supported depending on the
transmitter.
Battery level display setting (BATT
REMAIN)
This sets the display method for the transmitter battery
level.
Note
Transmitter
Receiver
Note
Note
Note