User's Manual

17
Cross Remote (RF REMOTE)
This function must be set to allow the wireless remote
control function to be used between the transmitter and
receiver.
OFF
: Stops the wireless remote control function.
ON: Starts the wireless remote control function with the
previously paired receiver.
PAIRING: Executes a new pairing.
For details, see “Using the Cross Remote” on page 17.
Using the Cross Remote
This receiver is equipped with a wireless remote control
function that can be used to set the parameters (low-cut
filter, attenuation operation, power save mode, etc.) of the
transmitter through the TX1/2 menu. This function makes
it easier to operate and manage the microphone system
while in the field.
This wireless control is 2.4 GHz IEEE802.15.4 compliant
and has no effect on the RF band of digital wireless audio.
This function is activated when pairing is established
between the transmitter and the receiver using the RF
REMOTE function.
If the software version is not suitable for use with this
receiver, the wireless remote control function may not
function. A software update may be necessary to enable
proper functioning. For details on software updates,
contact your Sony service representative.
For details on transmitter software versions that are
compatible with this receiver, see “Transmitter software
version” on page 23.
Pairing with a transmitter
The transmitter that you want to control using the wireless
remote control function is linked to the receiver via the
pairing operation.
In addition to using the following procedure, you can also
set the POWER switch on tuner 1 or tuner 2 to ON while
holding down the – button to pair the transmitter with the
tuner that you turned ON.
1 Press the MENU SELECT button repeatedly until the
TX1/2 menu is displayed.
2 Press the + or – button repeatedly until the RF
REMOTE indication is displayed.
3 Hold down the SET button until the item to be set
flashes.
4 Press the + or – button repeatedly to select PAIRING.
5 Press the SET button to enter the setting.
Before proceeding to the next step, set the transmitter
to be controlled to pairing mode.
For details, refer to the operating instructions
supplied with the transmitter.
The receiver starts searching for a transmitter and then
displays the transmitter name with which pairing can
be executed.
During the search, pressing any operation key on the
receiver will cancel pairing mode.
Note