User's Manual

13
interface and the audio signal from the transmitter is
compressed.
– 20 dBFS ST LIMIT: The reference level is changed to
–20 dBFS (as in the –20 dBFS LIMITER mode above) and
audio signal compression is linked for tuner 1 and tuner 2.
Select this setting when sending stereo audio signals using
2 transmitters.
Selecting the sync signal (SYNC SOURCE)
Selects the sync signal source for the receiver when it is
attached through the optional DWA-01D/F01D wireless
adapter. The receiver supports an external sync signal
(word clock) of 32 kHz –6% to 96 kHz +6%.
For details on locking the sync signal, refer to the
operating instructions supplied with the adapter.
INTERNAL: The internal sync signal (48 kHz) is used.
AUTO
: The external sync signal is used on a priority
basis. When there is no external sync signal input, the
internal sync signal is used automatically. The currently
selected sync signal is displayed “INTERNAL” or
“EXTERNAL.”
EXTERNAL: Synchronization with an external word
clock signal. The current synchronization status is
displayed “UNLOCK” or “LOCK.”
When “EXTERNAL” is selected, digital signals and
analog signals will be output only if there is an external
word clock signal input.
Terminating the sync signal
(WORD SYNC 75ohm)
This function provides termination for the WORD SYNC
connector on the DWA-01D/F01D wireless adapter.
ON
: 75-ohm termination is added.
OFF: 75-ohm termination is not added.
When the receiver is turned off, the termination is released.
Selecting output 1 (ANALOG OUTPUT1)
Selects the OUTPUT1 connector of the DWA-01D/F01D
wireless adapter.
When the OUTPUT2 connector of the adapter is being
used for AES/EBU output, the OUTPUT1 connector can
be used for sub-output.
RX1
: Outputs the audio signal received on tuner 1.
RX2: Outputs the audio signal received on tuner 2.
RX1+2: Mixes and outputs the audio signals received on
tuners 1 and 2.
Automatic scan/sync function (AUTO
SCAN/SYNC)
Run the automatic scan/sync function.
For details, see “Using the automatic scan/sync function”
on page 8.
Showing the accumulated use time
(TIME)
You can display the accumulated battery use time as a
rough estimate of total receiver usage.
The factory setting is “00:00”.
Resetting the accumulated time indication
1 Hold down the SET button until the time indication
flashes.
2 Press the – button so “00:00 RESET” appears, and
then press the SET button.
Setting the brightness of the display
(BRIGHTNESS)
Ten levels of brightness can be selected for the organic
light-emitting diode display.
The selectable settings are the following:
(Dark) 1 2 3 4 5 6 7
8 9 10 (Bright)
Automatic dimming of the display
(DIMMER MODE)
The organic light-emitting diode display can be set to dim
or turn off after a certain amount of time.
AUTO OFF: The display turns off after 30 seconds. The
display goes on again when you press the SET, +, or –
button.
AUTO DIMMER
: The display dims after 30 seconds. The
display becomes bright again when you press the SET, +,
or – button.
ALWAYS ON: The display stays on at the brightness
level set with the BRIGHTNESS function.
Setting memory function (USER MEMORY)
Various settings can be stored in the receiver and then
loaded.
When you execute SAVE, the values for the following
settings will be saved.
UTILITY menu
• BAND BLOCK
• AES/EBU LVL@MIC
• SYNC SOURCE
• WORD SYNC 75ohm
Note
Note