user manual

Menu List
A-30 Appendix
Appendix
Item number Item
606 TCG MODE select [preset]
regene
auto
Selects the time code to which the internal time code
generator synchronizes.
preset: By an operation on the front panel or by remote
control from a device connected to the REMOTE 1-IN
(9P) connector, the initial value of the time code
generated by the internal time code generator can be
preset.
regene: The internal time code generator is synchronized
(“regene”) to the time code values read by the internal
time code generator.
auto: Operates in regene mode when either assemble or
insert mode is selected and operates in preset mode
when any other mode is selected.
607 TCG REGENE
SOURCE select
[int-LTC]
int-VITC
ext-LTC
ext-VITC
If item 606 is set to “regene,” this selects the source of the
synchronization of the time code generated internally.
int-LTC: When the time code played back from the time
code track on the tape is used.
int-VITC: When the time code played back from the “AUX
data” in the video signal on the tape is used.
ext-LTC: When the external time code input to the TIME
CODE IN connector is used.
ext-VITC: When the external time code input to the HD SDI
INPUT connector is used.
608 TCG/UBG
REGENE MODE
[TCUB]
TC
UB
Selects the regenerate signal when the time code generator
is in regenerate mode (when item 606. is set to regene) or
during auto edit mode.
TC & UB: The time code signal and user bits signal are both
regenerated.
TC: The time code signal is regenerated.
UB: The user bits signal is regenerated.
&
609 REC RUN/FREE
RUN select
[freerun]
rec run
This selects the way in which the time code advances.
free run: Regardless of the operating mode of this unit, the
time code advances all the time that the power is on.
rec run: The time code advances only during recording.
Note
When using this setting, set item 606. to “preset”.
610 VITC (SD) [off]
on
Selects whether or not to insert VITC data in the HD-SD
converter output.
off: VITC data is inserted.
on: VITC data is not inserted.
Settable range Function
611 VITC POSITION-1
select (NTSC)
12 line
.
.
.
[16line]
.
.
.
20 line
When an HKDV-501A (optional HD-SD Converter Board) is
installed and 29.97PsF/59.94i mode is selected on the
VTR, this setting specifies the lines in which the VITC
signal is inserted.
It can be inserted in any lines from 12 to 20.
Note
Items 611 and 612 allow VITC to be inserted in two lines.
612
VITC POSITION-2
select (NTSC)
12 line
.
.
.
[18line]
.
.
.
20 line
When an HKDV-501A (optional HD-SD Converter Board) is
installed and 29.97PsF/59.94i mode is selected on the
VTR, this setting specifies the lines in which the VITC
signal is inserted.
It can be inserted in any lines from 12 to 20.
Note
Items 611 and 612 allow VITC to be inserted in two lines.