User Guide

62
)
8
1¡$›
•¶
£7
Start ID
The start ID indicates the beginning of
each selection.
You can start playback from the start ID
position. (Page 58.)
There are three ways to write start ID:
• Writing automatically during recording
• Writing manually at the desired position
during recording
• Writing manually at the desired position
during playback
Note
While the start ID is being written, all
buttons except the 7 button are not
operative.
Writing Automatically during
Recording
1 Make sure that the AUTO indicator
is lit. If it is not, press the START ID
AUTO button.
When turning on the power and
inserting a cassette with its safety tab
at the record-possible position, the
AUTO indicator lights automatically.
In time recording, this indicator will be
the same as the one before the power
is turned off. Start IDs will be
recorded automatically when the
AUTO indicator lights.
2 To start recording, press the ¶REC
button, then press the 8PAUSE or
3 (play) button.
When the non-signal level lasts for
more than 3 seconds and a selection
then starts, the start ID is written
automatically for 9 seconds (18
seconds in the long-play mode). The
program number is also written
simultaneously. (Page 70.)
While a start ID is being written, the
START ID indicator flashes on the
display.
1
2
2
¶
REC
8
PAUSE
3
\
1
2
AUTO
START ID