User's Guide / Troubleshooting
Table Of Contents
- IMPORTANT SAFEGUARDS
- Read this first
- Notes on using your camera
- Before your operation
- Using the shooting functions
- Using the viewing functions
- Using the menu
- Using your computer
- Enjoying your computer
- Connecting the camera and your computer
- Copying images to your computer
- Image file storage destinations and file names
- Copying images stored on a computer to amemory card and viewing the images
- Using the software (supplied)
- Installing the software
- Using the “Picture Motion Browser”
- Using the “Image Data Converter SR”
- Using the “Image Data Lightbox SR”
- Using the “Remote Camera Control”
- Printing images
- Troubleshooting
- Others
- Index
60
For details on the operation
1
page 55
To shoot with the Remote Commander, set the drive mode to (Remote Commander).
Verify that the subject is visually in focus, and point the transmitter at the remote sensor
located on the front of the camera, then press the SHUTTER or 2 SEC button.
• You cannot use the other drive modes (Continuous advanced, etc.).
• To lock the focus (focus lock shooting, page 51), press the shutter button on the camera halfway down and
release the button, then shoot with the Remote Commander. After shooting, the focus remains locked.
Any operation on the camera will release the focus lock.
• In BULB shooting (page 43), the camera starts exposure right away when you press the SHUTTER
button, and the camera starts exposure two seconds later when you press the 2 SEC button. By pressing
the SHUTTER or 2 SEC button again, the exposure will be done right away.
• The other buttons are used when the camera is connected to a TV (pages 91, 148).
Shooting with the Remote Commander
Transmitter
SHUTTER button
When the button is pressed, the shutter is released right away.
2 SEC button
After you press the button, the shutter is released about two seconds
later.