User's Guide / Troubleshooting
Table Of Contents
- IMPORTANT SAFEGUARDS
- Read this first
- Notes on using your camera
- Before your operation
- Using the shooting functions
- Using the viewing functions
- Using the menu
- Using your computer
- Enjoying your computer
- Connecting the camera and your computer
- Copying images to your computer
- Image file storage destinations and file names
- Copying images stored on a computer to amemory card and viewing the images
- Using the software (supplied)
- Installing the software
- Using the “Picture Motion Browser”
- Using the “Image Data Converter SR”
- Using the “Image Data Lightbox SR”
- Using the “Remote Camera Control”
- Printing images
- Troubleshooting
- Others
- Index
126
For details on the operation
1
page 32
• After the image sensor vibrates for a short time, the mirror in front is lifted.
4 Detach the lens.
5 Use the blower to clean the image sensor surface and the surrounding area.
• Do not touch the image sensor with the tip of the blower. Complete the cleaning quickly.
• Hold the camera’s face downward to prevent the dust from resettling in the camera.
• Do not use a spray blower because it may scatter vapor inside the camera body.
•
When cleaning the image sensor, do not put the tip of a blower into the cavity
beyond the lens mount. You do not need to put the blower close to the image
sensor.
6 Attach the lens and set the POWER switch to OFF.
• The camera starts beeping if the battery pack becomes low during cleaning. Stop the cleaning
immediately and set the POWER switch to OFF.
z To keep dust from entering the camera
• Choose a location with little dust to change the lens, and complete the operation quickly.
• Do not leave the camera without a lens or the body cap.
• When attaching the body cap, remove all the dust from the cap before placing it on the camera.
You can reset the main functions of the camera.
1 Select [Reset default], then press the center of the multi-selector.
The message “Reset default?” appears.
2 Select [OK] with v on the multi-selector, then press the center of the multi-selector.
The main functions are reset.
• For details on the items to be reset, see “Reset default” (page 172).
Reset default