User's Guide / Troubleshooting
Table Of Contents
- IMPORTANT SAFEGUARDS
- Read this first
- Notes on using your camera
- Before your operation
- Using the shooting functions
- Using the viewing functions
- Using the menu
- Using your computer
- Enjoying your computer
- Connecting the camera and your computer
- Copying images to your computer
- Image file storage destinations and file names
- Copying images stored on a computer to amemory card and viewing the images
- Using the software (supplied)
- Installing the software
- Using the “Picture Motion Browser”
- Using the “Image Data Converter SR”
- Using the “Image Data Lightbox SR”
- Using the “Remote Camera Control”
- Printing images
- Troubleshooting
- Others
- Index
125
For details on the operation
1
page 32
Setup menu
Setup menu 3
The default settings are marked with .
In the default setting, when you press the MENU button, the 1 or 1 menu screen is
displayed first. You can change this setting to display the previously selected menu screen
first.
Before deleting images or folders, a confirmation screen, such as “Delete images?”, appears.
Normally, [Cancel] is selected by default, but you can set this default option so that [Delete] is
selected.
Selects the sound produced when the shutter is locked, during self-timer countdown, etc.
If dust or debris enters the camera and lands on the image sensor (the part that acts as the
film), it may appear on the photo image, depending on the shooting environment. If there is
dust on the image sensor, use a commercially available blower and clean the image sensor
following the steps below. You can easily clean the image sensor using only the blower and
the anti-dust function.
• Cleaning can be performed only when the battery level is (three remaining
battery icons) or more. Low battery power during cleaning can cause damage to
the shutter. The cleaning should be completed quickly.
1 Confirm that the battery is fully charged.
• The use of an AC Adaptor/charger (not supplied) is recommended.
2 Select [Cleaning mode], then press the center of the multi-selector.
The message “After cleaning, turn camera off. Continue?” appears.
3 Select [OK] with v on the multi-selector, and press the center of the multi-selector.
Menu start
Top
Displays the 1 or 1 menu screen first.
Previous
Displays the previously selected menu screen first.
Delete confirm.
“Delete” first
[Delete] is selected by default.
“Cancel” first
[Cancel] is selected by default.
Audio signals
On
Turns on the sound.
Off
Turns off the sound.
Cleaning mode