Computer Applications Guide
Table Of Contents
- Read this first
- Read this first 2
- Connecting to a Windows computer
- Introduction to editing pictures on a computer 6
- Step 1: Installing the USB driver on a computer 8
- Step 2: Installing the image editor software (ImageMixer Ver.1.5 for Sony) 9
- Step 3: Installing the image exchange software (Image Transfer) 11
- Step 4: Connecting your camcorder to a computer 13
- Step 5: Checking the connection 17
- Managing pictures on a Windows computer
- Connecting to a Macintosh computer (“Memory Stick” only)
- Other functions
- Additional information
- Connecting to a Windows computer
- Introduction to editing pictures on a computer
- Step 1: Installing the USB driver on a computer
- Step 2: Installing the image editor software (ImageMixer Ver.1.5 for Sony)
- Step 3: Installing the image exchange software (Image Transfer)
- Step 4: Connecting your camcorder to a computer
- Step 5: Checking the connection
- Managing pictures on a Windows computer
- Connecting to a Macintosh computer (“Memory Stick” only)
- Other functions
- Additional information
Connecting to a Windows computer
G:\BackUP(E)\PC(3084946111)\0729PC_GB\3084946111\3084946111_PC\01US02WIN1.fm
master:Right
Connecting to a Windows computer
15
DCR-PC330/IP1
3-084-946-11(1)
9 Slide the POWER switch repeatedly to
select the PLAY/EDIT mode.
10Touch [P-MENU], [MENU] and [USB-
PLY/EDT], then touch to select [STD-
USB].
11Connect your camcorder to the
computer via the USB cable (p. 14).
[USB MODE] appears on the LCD screen
of your camcorder and the computer starts
to recognize the camcorder.
It may take some time for the computer to
recognize the camcorder when you connect
the USB cable for the first time.
For Windows XP
If [Found New Hardware Wizard] appears,
click [Continue Anyway] and complete the
installation.
To disconnect the USB cable
For Windows 2000/Windows Me/
Windows XP
If [USB MODE] appears on the LCD screen,
follow the procedure below to disconnect the
USB cable.
1 Click the [Unplug or Eject Hardware]
icon on the task tray.
2 Click [Unplug or eject hardware]
([Safely remove Sony Camcorder] in
Windows XP).
3 Click [OK].
4 Disconnect the USB cable from the
camcorder and computer.
If [USB MODE] does not appear on the LCD
screen, do only step 4 above.
For Windows 98/Windows 98SE
Do only step 4 above.
Recommended connection
Connect as shown in the following illustrations
to operate the camcorder correctly.
• Connect the camcorder to a computer via the
USB cable (supplied). Make sure no other
USB devices are connected to the computer.
Click this icon.
task tray
Click here.
,continued