Operating Instructions

Getting Started

3 Adjust the speaker slowly with the

attached tape in place to prevent the

speaker cord (and the AC power cord

(mains lead) of the surround speaker

(L)) from being pinched between the

speaker and the pole.

Do not pull the speaker cord too strongly, or

the speaker cord will separate from the

speaker.

4 Attach the cover (S) and slide the

speaker until it stops.

5 Attach the back cover.

Notes

• To prevent the speaker falling, keep the speaker

horizontal while adjusting the height.

• If you take off the speaker cord, slide the speaker

contrary in step 3. Next, unfasten the stopper and

remove the speaker. Then attach the speaker cord and

adjust the height of the speaker.

Adjusting the angle of the center

speaker

You can set the angle by adjusting the screws.

Tip

You can install the front speakers and the surround

speakers on a wall using the optional kit (not supplied).

e.g., the surround

speaker (L)

e.g., the surround

speaker (L)

Screws

continued