3-856-227-12(1) Mini Hi-Fi Component System Operating Instructions CHC-P33D © 1996 by Sony Corporation
Chapter 1: Setting Up Connecting the Stereo AM loop aerial connection Connect the supplied loop aerial to the AM and the y terminals. Connecting the Stereo Use the illustrations below to connect your stereo. If you want to connect any optional components to the stereo, see “Connecting Optional Equipment” in Chapter 6.
Right satellite speaker Superwoofer AM loop aerial Left satellite speaker FM lead aerial STEP 2 STEP 1 STEP 3 to a wall outlet Do this connection last! STEP 3 Connecting the Power Connect the mains lead to a wall outlet after you have made all the above connections. Note Do not install the woofer close to the unit, and do not place the woofer above or below the unit. Otherwise, the vibration from the woofer may cause mechanical noise or “skipping”.
➔ continued Fastening the speaker stands 2 Use a screw driver to attach the stands to the wall with four wood screws (not supplied). display. You need to set the clock to utilise the timer-activated features of your stereo system. DISPLAY 1 Fasten the four screws loosely using the supplied wrench. Wrench + = 1 3,5 2,4 3 Re-attach the caps and plates to the speaker stands. Screw 2 Rotate the speaker to the desired position. You can also rotate the Sony logo.
For Your Information Precautions Troubleshooting Guide Maintenance Specifications Index to Parts and Controls Index Precautions If you have any questions or problems concerning your stereo system, please consult your nearest Sony dealer. On safety •The unit is not disconnected from the AC power source (mains) as long as it is connected to the wall outlet, even if the unit itself has been turned off. •Unplug the system from the wall outlet (mains) if it is not to be used for an extended period of time.
CD Player The disc tray does not close. ➔ The CD is not placed correctly. The CD will not play. ➔ The CD is dirty. ➔ The CD is inserted label side down. ➔ The player is in pause mode. ➔ Moisture condensation has builtup. Leave the system turned on for about an hour until the moisture evaporates. Play does not start from the first track. ➔ The CD player is in programme or shuffle mode. Press PLAY MODE repeatedly so that “PROGRAM” or “SHUFFLE” disappears. “ ” is displayed.
Mass Amplifier section DIN power output: Satellite: 7 W + 7 W (4 ohms at 1 kHz, DIN) Superwoofer: 30 W (6 ohms at 60 Hz, DIN) Continuous RMS power output Satellite: 10 W + 10 W (4 ohms at 1 kHz, 10% THD) Superwoofer: 35 W (6 ohms at 60 Hz, 10% THD) Music power output Satellite: 15 W + 15 W (4 ohms at 1 kHz, 10% THD) Superwoofer: 45 W (6 ohms at 60 Hz, 10% THD) Inputs MD IN: Sensitivity 450 mV, impedance 47 kilohms Outputs MD OUT: Sensitivity 250 mV, 1 kΩ PHONES (stereo phone jack): accept headphones of 8 o
➔ continued Note A or B lights up when you operate CD player or tuner. However, you can ignore it.
