SON'S.
Parts list The numbers in the list are keyed to those in the instructions. ® ® @ ® ® ® x2 ® ® x4 Caution Cautionary notice for handling the bracket 1. Handle the bracket carefully to avoid injuring your fingers.
Installation Precautions • Do not tamper with the four holes on the upper made only by service technicians. • Choose the installation location carefully • Avoid installing the unit in areas subject in direct sunlight or near heater duct. • Use only the supplied mounting surface of the unit. They are for tuner adjustments so that the unit will not interfere driving. to dust, or high temperatures, hardware dirt, excessive for a safe and secure vibration, installation.
Mounting angle adjustment Adjust the mounting angle to less than 60 _. B To attach Attach part (_) of the front panel to part ® of the unit as illustrated and pushthe left side into position until it clicks.
Mounting example Installation in the dashboard 2 1 Bend these claWS outward for a tight fit, if necessary.
3 Note To prevent malfunction, install (_ max. size 5 × 6 mm only with the _uppli_d screws _, To support Flre wsII the unit Dashboard max. size M4 x 6 mm ® NISSAN (_) max. _ze 5×6mm to dashbom'd/center console ) max.
3
Connections Caution • This unit is designed • Before making for negative connections, ground disconnect 12 V DC operation the ground terminal only. of the car battery to avoid short circuits. • Connect the yellow and red power input leads only after all other leads have been connected. • Be sure to connect the red power input lead to the positive 12 V power terminal which is energized when the ignition key is in the accessory position. • Run all ground wires to a common ground point.
Connection example CDX-1300 Fuse (10 A) to the power antenna control lead or power supply lead of antenna booster amplifier Notes • It is not necessary to connect this lead if there is no power antenna or antenna booster, or with a manually-operated telescopic antenna. • When your car has a built-in FM/AM antenna m the mar/side glass, see "Notes on the control leads. " ANT REM Blue Max. supply current 0,1 A White BlueJWhite striped Max. supply current 0.
Rear speakers (not supplied) from car antenna Power amplifier (not supplied) RCA pin cord (not supplied) striped AMP REM AMP REMOTE IN current 0.3 A O to the +12 V power terminal which is energized in the accessory position of the ignition key Note If there is no a_cessoryposition, connect to the +12 V power (battery) terminal which is enecgiazed at all times. Be sure to connect the black ground lead to it first.
J Left Yellow Green/Black striped Rear speakers (not supplied) Purple f---o ,_';-=2) Right Black Purple/Black striped Notes on the control leeds • The ANT REM lead (blue) supplies + 12 V DC when you turn on the tuner. • When your car has a built-in FM/AM antenna in the rear/side glass, it is necessary antenna control lead (blue) or the accessory power input lead (red) to the power antenna booster. For details, consult your dealer.
0 to the +12 V power terminal which Is energized at all times Be sure to connect the black ground lead to it first. to a metal _ _ Notes on speaker connection • Before connecting the speakers, • U_e speakers with an impedance point of the car First connect the black ground power input leads. turn the unit off. of 4 to 8 ohms, and with adequate lead, then connect the yellow power handling capacities. speakers may be damaged.
JHn_maprMnm_j Imj!!,,, Sony Corporation Printed in USA
