Operating Instructions - Operating Instructions
Table Of Contents
- Table of Contents
- Precaution
- On Safety
- On Installation
- Transportation of the Unit
- Connecting to Other Devices
- Handling the Screen
- On High Brightness Display
- On Burn-in
- On a Long Period of Use
- On the Surface of the Unit
- On Long Periods of Continuous Use
- Handling and Maintenance of the Screen
- On Dew Condensation
- Notes on Security
- On Repacking
- Disposal of the Unit
- On the Software Updates
- On Fan Error
- Location and Function of Parts and Controls
- Preventing Falling of the Monitor (BVM-E251)
- Mounting the Unit in a Rack (BVM-E171)
- Attaching the Handle (BVM-E171)
- Connecting the Controller (BKM-17R)
- Connecting Multiple Units with the LAN
- Connecting the HDMI cable
- Connecting the Power Cord
- Initial settings
- Setting for the LAN to Connect Multiple Units
- Selecting the Monitor (Designation of the Monitor or Group ID Number)
- Using the Menu
- Protection of the Setting Values
- Adjustment Using the Menus
- Displaying the Monitor Status Page
- Upgrading the Monitor and Controller
- Extending the Monitor Function with the Optional License (BVM-E171 only)
- Connecting the SDI Signals
- Troubleshooting
- Specifications
- Dimensions
- Precaution
Displaying the Monitor Status Page
75
Displaying the Monitor
Status Page
When Status has been assigned to a function button of
the controller, various information, such as the setting
status, display mode, and input signal information of the
currently displayed video signal, are displayed on the
monitor status pages.
For how to assign a function to a function button, see
“Assigning a Function to a Function Button” (page 73).
Note
[Pixel Zoom] is not set to on when the monitor status
page is displayed.
1
Press the STATUS button on the controller to set it
to On.
Page 1/3 of [STATUS] display is displayed.
2
Select the [STATUS] page you wish to view using
the UP/DOWN button on the controller.
You can select the [STATUS] page from among 1/3,
2/3, and 3/3.
For the contents of each page, see below.
To cancel the display of the [STATUS] page
Press the STATUS button on the controller again.
Page 1/3
Information on the setting status of the input signal and
the display mode is displayed.
[CH]: Displays the currently selected channel number
and channel name.
[Detected Signal]: Displays the signal system with the
format detected.
[Format]: Displays [Format] set in the [Channel
Configuration] menu.
[Input No]: Displays [Input No] set in the [Channel
Configuration] menu.
Submenu Setting
[Key Protect] Sets the key protection.
[On]: The button on the controller
(except the menu operation buttons
and monitor selection buttons) and
the parallel remote do not function
and other settings are not
changeable.
[Off]: Release the lock.