Operating Instructions - Operating Instructions
Table Of Contents
- Table of Contents
- Precaution
- On Safety
- On Installation
- Transportation of the Unit
- Connecting to Other Devices
- Handling the Screen
- On High Brightness Display
- On Burn-in
- On a Long Period of Use
- On the Surface of the Unit
- On Long Periods of Continuous Use
- Handling and Maintenance of the Screen
- On Dew Condensation
- Notes on Security
- On Repacking
- Disposal of the Unit
- On the Software Updates
- On Fan Error
- Location and Function of Parts and Controls
- Preventing Falling of the Monitor (BVM-E251)
- Mounting the Unit in a Rack (BVM-E171)
- Attaching the Handle (BVM-E171)
- Connecting the Controller (BKM-17R)
- Connecting Multiple Units with the LAN
- Connecting the HDMI cable
- Connecting the Power Cord
- Initial settings
- Setting for the LAN to Connect Multiple Units
- Selecting the Monitor (Designation of the Monitor or Group ID Number)
- Using the Menu
- Protection of the Setting Values
- Adjustment Using the Menus
- Displaying the Monitor Status Page
- Upgrading the Monitor and Controller
- Extending the Monitor Function with the Optional License (BVM-E171 only)
- Connecting the SDI Signals
- Troubleshooting
- Specifications
- Dimensions
- Precaution
Adjustment Using the Menus
61
To set to the native scan mode
Set [Native Scan] to [On].
To select the scan mode
1
Set [Native Scan] to [Off].
2
Select [Scan Mode], then select scan mode from the
following.
[Normal Scan]: Normal mode
[Under Scan]: Under mode
[Over Scan]: Over mode
Note
The scan mode is not selectable in the following cases:
When [Native Scan] is set to [On]
When the internal signal is displayed
When [Side by Side], [Wipe], [Butterfly], or
[Blending] is set to [On]
[System Configuration] Menu
This menu is used to set the system such as the network,
parallel remote control function, etc.
When [System Configuration] is selected, the following
menu is displayed.
BVM-E251
BVM-E171
[Network]
Sets the remote control function of the network.
[Monitor ID]
Enter a monitor ID number.
Set to 01 to 99. (Default value: [01])
[Group ID]
Enter a group ID number.
Set to 01 to 99. (Default value: [01])
[Network Setting]
Sets the IP address, subnet mask, and default gateway.
For the setting value, consult the network administrator.