Operating Instructions - Operating Instructions
Table Of Contents
- Table of Contents
- Precaution
- On Safety
- On Installation
- Transportation of the Unit
- Connecting to Other Devices
- Handling the Screen
- On High Brightness Display
- On Burn-in
- On a Long Period of Use
- On the Surface of the Unit
- On Long Periods of Continuous Use
- Handling and Maintenance of the Screen
- On Dew Condensation
- Notes on Security
- On Repacking
- Disposal of the Unit
- On the Software Updates
- On Fan Error
- Location and Function of Parts and Controls
- Preventing Falling of the Monitor (BVM-E251)
- Mounting the Unit in a Rack (BVM-E171)
- Attaching the Handle (BVM-E171)
- Connecting the Controller (BKM-17R)
- Connecting Multiple Units with the LAN
- Connecting the HDMI cable
- Connecting the Power Cord
- Initial settings
- Setting for the LAN to Connect Multiple Units
- Selecting the Monitor (Designation of the Monitor or Group ID Number)
- Using the Menu
- Protection of the Setting Values
- Adjustment Using the Menus
- Displaying the Monitor Status Page
- Upgrading the Monitor and Controller
- Extending the Monitor Function with the Optional License (BVM-E171 only)
- Connecting the SDI Signals
- Troubleshooting
- Specifications
- Dimensions
- Precaution
Dimensions
103
When the controller is attached with the
BKM-39H
Front
Side
Top
BVM-E251/E171
Unit: mm (inches)
Notes
Make sure to tighten the screws using the screwdriver
which conforms to the supplied screws.
When using an electric screwdriver, set the torque
setting as follows.
For M4 screws: approximately 1.2 N·m [12 kgf·cm]
When installing on a vehicle, secure the unit to the
vehicle using the M4 screw holes on the sides of the
unit.
(The tilt angle is within 10° of the angle of depression)
* Length of M4 screws (side, rear)
Monitor cabinet
Attached object
6 (
1
/
4
) to 8 (
11
/
32
)
M4 screw