Specifications

61
Techinical Appendix
14.7 Function priority
This table shows which setting takes priority over the other in each function when the
BRC-H900/BRC-H700/BRC-Z700/BRC-Z330/BRC-300/300P is connected to the BRU-SF10/BRU-H700/BRU-
300/300P.
BRC cameras BRU
RS-232C/RS-422 control disable enable
DATA MIX setting disable enable
VISCA ID setting disable* enable
VIDEO OUT enable enable
* The camera number setting at camera unit should be 0 (Auto).
To assign VISCA ID to each camera, please set it on BRU side.
Wire
Flat-head screwdr
iver
14.8 Using the VISCA RS-422 Connector Plug
1 Insert a wire (AWG Nos. 28 to 18) into the desired
wire opening on the VISCA RS-422 connector
plug, and tighten the screw for that wire using a
flathead screwdriver.
2 Insert the VISCA RS-422 connector plug into the
VISCA RS-422 connector.
To remove the connector plug
Grasp both ends of the VISCA RS-422 connector
plug and pull it out as shown in the illustration.
•Inordertostabilizethevoltagelevelofthesignal,
connect both ends to GND.
•WhenyoumakeconnectionsusingVISCARS-422
connectors, the VISCA RS-232C connection is not
available.
•ThemaximumconnectiondistancewithVISCA
RS-422 connection is approximately 1,200 m
(3,937 ft).
Note