Specifications

44
Operation with the RM-IP10 IP Remote Controller
8.2 System Configuration
,
PC for the setting
IP remote controller RM-IP10*
IP remote controller RM-IP10*
Video switcher
Camera
BRC-H900, BRC-Z700,
BRC-Z330
IP control card
BRBK-IP10, BRBK-IP7Z
Camera
BRC-H900, BRC-Z700,
BRC-Z330
IP control card
BRBK-IP10, BRBK-IP7Z
Camera
BRC-H900, BRC-Z700,
BRC-Z330
IP control card
BRBK-IP10, BRBK-IP7Z
HD video monitor
*
Switching hub
Remote control (LAN) signal
Tally/contact signal
Video signal
Signal flow
*Connect the tally connector (outputs the camera number that is on-air) of the video switcher to the TALLY/CONTACT connec-
tor of RM-IP10. If there are multiple RM-IP10s, connect the same signal to all the TALLY/CONTACT connectors. In this case, set the
TALLY/CONTACT switch (DIP 1 switch 4 and 5) to the ON AIR TALLY mode for all RM-IP10s. When a camera is on-air, the CAMERA
button on RM-IP10 lights in red. (This function will be supported by version 2.0 or later).
For details of connection and settings, refer to the operating instructions of the IP remote controller.
•YoucannotusetheRS-232CandRS-422connectionswhenusingtheIPconnection.WhenBRBK-IP10/IP7Zisattached
to the camera, the RS-232C/RS-422 connector does not work.
•WhenoutputtinganHD-SDIsignalfromBRBK-IP7Z,thesignaldelaysabout4HincomparisonwithaY/Pb/ProrRGB
signal that is output from the camera.
Note