Specifications

26
Location and Function of Parts
5.3.7 BRBK-HSD1 HD/SD-SDI Output
Card
1
SDI OUTPUT connectors (BNC-type)
Supplies down-converted SD-SDI signals that
conform to SMPTE259M (for 59.94i signal
format) and ITU-R BT.656 (50i signal format)
serial digital interface standards, and HD-SDI
signals that conform to the SMPTE292M serial
digital interface standard. Select HD-SDI or
SD-SDI signals with the HD/SD select switch.
HD/SD select switch
Set the switch to SD to supply SD-SDI signals
and HD to supply HD-SDI signals.
SDI OUTPUT
BRBK-HSD1
SD HD
1 2
•SD-SDIandHD-SDIsignalscannotbesupplied
simultaneously.
•SettheSD/HDselectswitchbeforeturningon
the camera.
Note
2
5.3.6 BRBK-MF1 HD Optical
Multiplex Card
1
AUDIO IN L/R jacks (phono-type)
Input an audio signal (stereo), which is output
from the AUDIO OUT jacks on the BRU-H700 HD
Optical Multiplex Unit via an optical fiber cable.
The time difference between video and audio
can be adjusted by up to 240 ms by 10
ncrements.
Optical connector
2
1 2
The audio input on this board accepts audio line
signals only. When you input audio signals from a
microphone or similar device, it should be
connected with a microphone amplifier so that
audio signals with an appropriate audio level
can be input.
Note
5.3.9 BRBK-303 Optical Multiplex
Card
1
Optical connector
1
5.3.10 BRBK-301 Analog RGB
Component Card
1
1
RGB/SYNC connector
5.3.11 BRBK-302 SDI Card
1
SDI connector
Supplies a signal conforming to the SMPTE259M
serial digital interface standard.
1
5.3.8 BRBK-HD2 HD-SDI Output
Card
1
SDI OUTPUT connectors (BNC-type)
The Card allows output of an HD-SDI signal
conforming to SMPTE292M serial digital interface
standards. No audio signal is output from the
card.
Pin No. Signal Pin No. Signal
1 GND 6 Composite/Y
2 GND 7 SYNC
3 R/Cr 8 GND
4 G/ Y 9 - /C
5 B/Cb
1