Specifications

25
Location and Function of Parts
5.3.2 HFBK-HD1 HD Interface Board
1
MONITOR connector (D-sub 15-pin)
1 2 3
2
DIP switches (inside the cap)
When this interface board is inserted into the
camera or the BRU-H700 HD Optical Multiplex
Unit, the DIP switches cannot be used.
The parameters can be set from the menu of
the camera.
HD-SDI connector (BNC-type)
Supplies HD-SDI signals that conform to the
SMPTE292M serial digital interface standard.
The two connectors output the same signal.
3
Pin No. Signal Pin No. Signal
1 R/Pr (X) 9 NC
2 G/ Y (X) 10 GND
3 B/Pb (X) 11 NC
4 NC 12 NC
5 GND 13 HD
6 R/Pr (G) 14 VD/SYNC
7 G/Y (G) 15 NC
8 B/Pb (G)
5.3.3 HFBK-SD1 SD Interface Board
1
MONITOR connector (D-sub 9-pin)
1 2 3 4
2
DIP switches (inside the cap)
When this interface board is inserted into the
camera or the BRU-H700 HD Optical Multiplex
Unit, the DIP switches cannot be used.
The parameters can be set from the menu of
the camera.
VIDEO connector (BNC-type)
Supplies analog composite signals. The aspect
ratio can be selected in the camera’s DOWN
CONVERTER menu.
3
Pin No. Signal Pin No. Signal
1 GND 6 Composite/Y
2 GND 7 SYNC
3 R/Cr 8 GND
4 G/ Y 9
- /C
5 B/Cb
4
AUDIO L/R jacks (phono-type)
Input audio signals (stereo). The input audio
signals are converted into signals that comply
with HDV standards. The time difference
between image and audio can be adjusted by
up to 240 minutes in 10 increments.
DIP switches (inside the cap)
When this interface board is inserted into the
camera or the BRU-H700 HD Optical Multiplex
Unit, the DIP switches cannot be used.
The parameters can be set from the menu of
the camera.
i.LINK (HDV) OUT connector (i.LINK 6-pin)
5.3.4 HFBK-XG1 XGA Interface Board
1 2
5.3.5 HFBK-TS1 HDV Interface Board
1
1 2 3
2
3
1
MONITOR connector (D-sub 15-pin)
2
DIP switches (inside the cap)
When this interface board is inserted into the
camera or the BRU-H700 HD Optical Multiplex
Unit, the DIP switches cannot be used.
The parameters can be set from the menu of
the camera.
Pin No. Signal Pin No. Signal
1 R (X) 9 NC
2 G (X) 10 GND
3 B (X) 11 NC
4 NC 12 NC
5 GND 13 HD
6 R (G) 14 VD
7 G (G) 15 NC
8 B (G)
SD-SDI connector (BNC-type)
Supplies down-converted SD-SDI signals that
conform to SMPTE259M (for 59.94i signal
format) and ITU-R BT.656 (for 50i signal format)
serial digital interface standards. The aspect
ratio can be selected with the camera’s DOWN
CONVERTER menu.