Specifications

14
Location and Function of Parts
5.1 BRC Series of Cameras
Location and Function of Parts
5
The following is a summary of the location and function of BRC-H900, BRC-H700, BRC-Z700, BRC-Z330, and
BRC-300/300P parts.
5.1.1 BRC-H900
Rear
VISCA RS-422 connector
75 Ω termination switch
This switch is used when an external sync signal
is used. Set it to OFF when this camera is in the
middle of a daisy-chain connection of multiple
cameras. Set it to ON when the camera is at the
end of a daisy-chain connection or when
nothing is connected to the EXT SYNC IN
connector on the camera.
IR SELECT switch
Select the camera number when you operate
multiple cameras with the same Remote
Commander.
Remote sensor
This is the sensor for the supplied Remote
Commander.
This remote sensor does not function when IMG
FLIP is set to ON in the SYSTEM menu.
HD/SD select switch
Outputs an SD-SDI signal from the SDI
connector when the switch is set to SD, or an
HD-SDI signal from the SDI connector when the
switch is set to HD.
RGB/COMPONENT connector
Pin No. Signal Pin No. Signal
1 Pr/R 9 NC
2 Y/G 10 GND
3 Pb/B 11 GND
4 GND 12 NC
5 GND 13 HD-OUT
6 GND 14 Tri-level Sync/Bi-level VD
7 GND 15 NC
8 GND
VISCA RS-232C IN connector
Connect to the RM-BR300 Remote Control Unit
(not supplied). When you connect multiple
cameras, connect it to the VISCA RS-232C OUT
connector of the previous camera in a daisy-
chain connection.
VISCA RS-232C OUT connector
When you connect multiple cameras, connect
it to the VISCA RS-232C IN connector of the next
camera in a daisy-chain connection.
EXT SYNC IN connector
VIDEO connector
S VIDEO connector
SDI connector
Outputs the video signal from the camera as
an HD/SD-SDI signal.
Supplies down-converted SD-SDI signals that
conform to the SMPTE 259M serial digital
interface standards, or HD-SDI signals that
conform to the SMPTE 292 serial digital interface
standards. Select HD-SDI or SD-SDI signals with
the HD/SD select switch.
Card slot
DC IN 12V connector
1
2
3
4
5
6
7
8
9
11
12
RGB/COMPONENT
VISCA RS-422
1 2 3 4 5 6 7 8 9
EXT SYNC IN
IR SELECT
75
1 2 3
OFF ON HD SD
IN VISCA RS-232 OUT SDI OUT
DC IN 12V
R
VIDEO S VIDEO
1 2 3 4 5 6
7 8 9 10 11 12 13 14
Set the switch before turning the camera on.
Note
10
13
14