Operating Instructions
Table Of Contents
- WARNING
- About These Operating Instructions
- Unpacking
- Index to Parts and Control
- Getting Started
- Playback
- Sound Adjustment
- Tuner
- Other Operations
- Using the Control for HDMI Function for “BRAVIA” Sync
- Calibrating the Appropriate Settings Automatically
- Setting the Speakers
- Using the Sleep Timer
- Deactivating the Buttons on the Unit
- Controlling Your TV with the Supplied Remote
- Changing the Brightness of the Front Panel Display
- Saving Power in Standby Mode
- Browsing Websites
- Setting up the Network
- Settings and Adjustments
- Additional Information
Other Operations
43
US
Controlling Your TV with
the Supplied Remote
By adjusting the remote signal, you can control
your TV with the supplied remote.
• When you replace the batteries of the remote, the
code number may reset itself to the default (SONY)
setting. Reset the appropriate code number.
Press and hold TV "/1 while entering your
TV’s manufacturer’s code (see the table)
using the number buttons. Then release TV
"/1.
If the setting is unsuccessful, the currently
registered code is not changed. Re-enter the
code number.
Code numbers of controllable
TVs
If more than one code number is listed, try
entering them one at a time until you find the
code that works with your TV.
Changing the Brightness
of the Front Panel
Display
Press DIMMER.
Each time you press DIMMER, the brightness of
the front panel display is changed.
Saving Power in Standby
Mode
Check that the following settings are both made:
– [Control for HDMI] in [HDMI Settings] is set
to [Off] (page 53).
– [Quick Start Mode] is set to [Off] (page 54).
Preparing the remote for
controlling the TV
Manufacturer Code number
SONY 01 (default)
LG 02
PANASONIC 05
SAMSUNG 02, 06
SHARP 03
TOSHIBA 04
VIZIO 07