User manual
Table Of Contents
- IMPORTANT SAFEGUARDS
- Read this first
- Notes on using your camera
- Table of Contents
- Preparing the camera
- Before your operation
- Shooting images
- Using the shooting function
- Selecting the focus method
- Zooming in in one step
- Using the flash
- Adjusting the brightness of the image (Exposure, Flash compensation, Metering)
- Shooting with fixed brightness (AE Lock)
- Using brightness compensation for the entire image (Exposure compensation)
- Adjusting the amount of flash light (Flash compensation)
- Selecting the flash control mode to set the amount of flash light (Flash control)
- Selecting the method for measuring the brightness of a subject (Metering mode)
- Setting ISO
- Adjusting the color tones (White balance)
- Image processing
- @/@ Selecting the drive mode
- Using the viewing function
- Changing your setup
- Viewing images on a computer
- Printing images
- Others
- Index
141
Printing images
Printing images
Specifying DPOF
Using the camera, you can specify the images and the number of images to
print before you print images at a shop or with your printer. Follow the
procedure below.
DPOF specifications are left with images after printing. It is recommended
that you unspecify them after printing.
Notes
• You cannot specify DPOF on RAW data files.
• You can specify any number up to 9.
• If you unspecify DPOF, the index print is also canceled.
MENU button t 1 t [DPOF setup] t [All images] or
[Cancel all] t [OK]
Specifying /unspecifying DPOF on selected images
1 MENU button t 1 t [DPOF setup] t [Marked images]
An image is displayed on the single screen.
2 Select the image with b/B on the controller.
3 Select the number of sheets with the / buttons.
• To unspecify DPOF, set the number to “0.”
4 Press the MENU button.
5 Select [OK] with v on the controller, then press the center of
the controller.
Specifying/unspecifying DPOF on all the images