4-178-676-19(1) LCD Digital Color TV Setting up your TV To watch TV Additional Information Setup Guide (Operating Instructions) Sony Customer Support U.S.A.: www.sony.com/tvsupport Canada: www.sony.ca/support United States 1.800.222.SONY Canada 1.877.899.
Owner’s Record The information label are located on the rear of the TV. For KDL–NX801/ 800 series models, they can be found by removing the bottom cover. Record model name and serial numbers on the information label in the spaces provided below. Refer to them whenever you call upon your Sony dealer regarding this TV. Model Name Serial No.
Table of Contents Checking the accessories..............................................................................................................4 Inserting batteries into the remote control .....................................................................................4 Setting up your TV Attaching the Table-Top Stand......................................................................................................6 Connecting the TV.........................................................
must use these screws instead of the ones provided with the bracket for safety reasons. Be sure to keep them in a safe place until you are ready to use the Wall-Mount Bracket. See page 23 for the recommended Wall-Mount Bracket for your TV.
Programming the Remote Control Your remote control can be programmed to use other equipment and is pre-programmed to operate the following Sony equipment. Function Button Sony Equipment Code Number DVD DVD Player 31033 AMP Receiver 52172 STB Digital Satellite 01639 Programming Other Equipment 2 2 4 3 4 Follow the steps below to program your TV remote control.
Setting up your TV Some TV models are packaged with a detached Table-Top Stand so you can mount your TV to a wall right away. If you are not mounting the TV to a wall, you will need to attach the TableTop Stand. You will need a Phillips screwdriver and the supplied screws to complete the task. Look for the attachment instructions provided with the TV. Be sure to consider the following while setting up your TV: • Disconnect all cables when carrying the TV.
For KDL-55NX811, KDL-60/55/ 46NX810, KDL-46/40NX711 and KDL-46/40NX710 Align with the two dowels of the TableTop Stand, and gently place the TV, checking the f mark is facing the front. 2 Attach the TV and Table-Top Stand with the supplied screw and hexagon wrench. Setting up your TV 1 ~ • Set the torque setting to approximately 3 N·m {30 kgf·cm}. Reattaching the Table-Top Stand to the TV Attach to the original position using the removed screws.
Adjusting the viewing angle (except 60-inch models) This TV can be adjusted within the angles shown below. For KDL-52/46NX800 and KDL-46/40NX700 0° 1 6° 4 3 2 Remove screw as shown. Install screw into the top screw hole of the Table-Top Stand. Lift up and tilt. Slide in. ~ • Reverse the steps when readjusting the angle back to 0 degree.
Connecting the TV The following chart shows the high-definition (HD) and standard-definition (SD) video formats supported by your BRAVIA TV inputs. (Continued) 9 Setting up your TV *1 720/24p format is supported by KDL-55NX811, KDL-60/55/46NX810, KDL-46/40NX711 and KDL-46/40NX710. *2 For supported PC formats refer to the i-Manual.
Shown with a Set Top Box with HDMI connection Shown with a Set Top Box with COMPONENT connection Set Top Box Set Top Box Cable System or VHF/UHF Antenna System Cable or Antenna 10
Shown with HD BRAVIA® Sync™ Basic Connection *Rear of TV *A/V Receiver AM SAT IN OPT IN SAT OPT IN VIDEO 1 COAX IN DVD DVD IN VIDEO 2/BD IN L L R R OUT AUDIO IN AUDIO IN AUDIO IN FRONT R FRONT L SUR R SUR L CENTER SUBWOOFER Setting up your TV *Blu-ray Disc COMPONENT VIDEO OUT VIDEO OUT DIGITAL OUT PCM/DTS/DOLBY DIGITAL COAXIAL OPTICAL PB/CB HDMI OUT PR/CR S VIDEO 5.
Shown with PC Connection with SD VCR/DVD Side Panel Rear of TV or PC Splitter VCR VCR/DVD Combo Cable/Antenna 12 Notebook PC DVD
Securing the TV Sony strongly recommends taking measures to prevent the TV from toppling over. Unsecured TVs may topple and result in property damage, serious bodily injury or even death. 1 Secure the Stand for the TV. Make sure the TV stand can adequately support the weight of the TV. Use two angle braces (not supplied) to secure the stand. For each angle brace use the appropriate hardware to: • Attach one side of the angle brace to the wall stud. • Attach the other side to the TV stand.
3 Anchor the TV to the Wall. Anchor the TV to the wall by using bolts, wall anchor and chain (or rope). ~ • KDL-60NX801, KDL-60/52/46NX800 and KDL46/40NX700 are shipped with screws attached to the rear of the TV. (They are fastened in the screw holes for wall mounting.) Be sure to remove the upper two screws prior to anchoring the TV on a wall. • Securing the TV to the stand without securing the TV and the stand to the wall provides minimum protection against the TV toppling over.
Running initial setup Detaching the Table-Top Stand from the TV Remove only the screws marked with the TV. on ~ • Do not remove the Table-Top Stand for any reason other than to install corresponding accessories on the TV. 2 3 Complete your cable connections before proceeding with the Initial Setup. Connect the TV to your nearest power outlet. Check the ENERGY SAVING SWITCH setting is on (z). Press 1 (POWER) on the TV.
Using a Wall-Mount Bracket Your TV can be mounted on a wall using a Wall-Mount Bracket (not supplied) out of the box as packaged. Some larger size TV may require detaching the Table-Top Stand; see “Detaching the Table-Top Stand from the TV” (page 15). Prepare the TV for the Wall-Mount Bracket before making cable connections.
To watch TV To watch programs 1 1-2 Turn on the TV. GUIDE OPTIONS HOME ~ • The TV image shown here may differ from your TV but the operation of your TV remains the same as indicated. 0-9 ENT 2 Select a TV channel. 2 To use the Guide Press GUIDE to display the TV Guide On Screen to view scheduled programs or to select a program to watch. Press again to exit the Guide. Use with 0-9 and ENT to select digital channels. For example, to enter 2.1, press , , , and ENT.
To use i-Manual Your BRAVIA TV comes with an on-screen manual. You can browse your i-Manual anytime you need to find the varieties of convenient functions. 1 1 Press i-MANUAL. 2 2 Press F/f/G/g/ select items.
Additional Information Troubleshooting The TV will indicate any problems with the STANDBY indicator flashing in red. When the STANDBY indicator is flashing The self-diagnosis function is activated. 1 Count how many times the STANDBY indicator flashes between each three second break. For example, the indicator may flash three times, go off for three seconds, then flash again three times.
How to Care for Your BRAVIA Safety is very important, please read and follow the safety documentation (Safety Booklet) separately provided. Unplug the TV and other connected equipment from the wall outlet before you begin cleaning your TV. • Wipe the LCD screen gently with a soft cloth. • Stubborn stains may be removed with a cloth slightly moistened with a solution of mild soap and warm water. • If using a chemically pretreated cloth, please follow the instruction provided on the package.
Specifications Model name KDL- 60NX801/ 60NX800 52NX800 46NX800 46NX700 40NX700 System Television system Panel system NTSC: American TV standard ATSC (8VSB terrestrial): ATSC compliant 8VSB QAM on cable: ANSI/SCTE 07 2000 (Does not include CableCARD functionality) Analog terrestrial: 2 - 69 / Digital terrestrial: 2 - 69 Analog Cable: 1 - 135 / Digital Cable: 1 - 135 LCD (Liquid Crystal Display) Panel Speaker output 10 W + 10 W Channel coverage Input/Output jacks 75-ohm external terminal for RF i
Model name KDL- 60NX810 55NX811/ 55NX810 46NX810 46NX711/ 46NX710 40NX711/ 40NX710 System Television system NTSC: American TV standard ATSC (8VSB terrestrial): ATSC compliant 8VSB QAM on cable: ANSI/SCTE 07 2000 (Does not include CableCARD functionality) Channel coverage Panel system Analog terrestrial: 2 - 69 / Digital terrestrial: 2 - 69 Analog Cable: 1 - 135 / Digital Cable: 1 - 135 LCD (Liquid Crystal Display) Panel Speaker output 8 W + 8 W + 10 W Input/Output jacks CABLE/ANTENNA VIDEO IN 1/
Declaration of Conformity Trade Name: SONY Model: KDL-60NX810/KDL-60NX801/KDL-60NX800/ KDL-55NX811/KDL-55NX810/KDL-52NX800/ KDL-46NX810/KDL-46NX800/KDL-46NX711/ KDL-46NX710/KDL-46NX700/KDL-40NX711/ KDL-40NX710/KDL-40NX700 Responsible Party: Sony Electronics Inc. Address: 16530 Via Esprillo, San Diego, CA 92127 U.S.A. Telephone Number: 858-942-2230 This device complies with part 15 of the FCC rules.
For Your Convenience Online Registration: Be sure to register your TV. United States Canada http://productregistration.sony.com http://www.SonyStyle.ca/registration Your TV is capable of receiving software updates. For the latest information about software updates for your TV, visit: Software Updates: United States Canada http://www.sony.com/tvsupport http://www.sony.
