Operating instructions

AD-5200A/S Operating Instructions
3
Sony Optiarc Europe
Rear View
Rear View P-ATA (A)
5 Jumper Block
These blocks of jumper set the
configuration for the DVD Writer (ref.
chapter ‘Installation of P-ATA drive’s
Jumper Setting’ for details).
6a Power Connector (P-ATA)
Use this to provide operating power
from the host computer.
7a I/O BUS Connector (P-ATA)
This BUS connector is used to control
the DVD Writer and data
transmission. Use a flat ribbon cable
to connect your computer to the DVD
Writer.
Rear View S-ATA(S)
6s Power Connector (S-ATA)
Use this to provide operating power
from the host computer.
7s I/O BUS Connector (S-ATA)
This BUS connector is used to control
the DVD Writer and data
transmission.
Installation of P-ATA drives
Jumper Setting
A jumper consists of a pair of pins and a
connector, which fits over the pins. When the
connector is in place it establishes an electronic
link between the pins, which enables the
function being controlled by the jumper. If the
connector is removed, the electronic link is
disconnected and the function is disabled.
Jumpers are used to set the DVD Writer mode
on the interface.
A
D-5200
A
/S Operating Instructions
4
Sony Optiarc Europe
The factory default setting is MASTER for
fitting to enhanced IDE controllers supporting
two ports, one for the hard disk and one for a
DVD Writer. If you prefer to connect the DVD
Writer to the same port as your hard disc, (as
a secondary device) you have to change
jumper setting to SLAVE mode.
Installing the DVD Writer in a host PC
(P-ATA)
1. Turn off the computer, other peripherals and
unplug all the cords and cables. Then remove
the computer cover, face plate, mounting clips,
and keeper bracket. Refer to the operating
guide that came with your computer for help
with this step.
2. If necessary, remove other devices above
the installation, approximately 50 ~70 mm (2 ~
3 in.), but do not disconnect the cables.
3. Slide the DVD Writer into the computer until
it is out approximately 50 ~ 70 mm (2 ~ 3 in.).
4. Locate a spare power cable in your
computer.
5. Connect that power cable to the power
connector on the back of the DVD Writer.
6. Connect the I/O BUS connector on the DVD
Writer and the IDE controller. Connect the
Coloured stripe side of the cable on the side
marked with the arrow (V).