User's Manual

Connecting when the dongle is placed
out of reach
Most users connect to the Miracast™ Wireless Display using the Connect button on
the dongle. This is the default connection mode. However, if the dongle is not placed
within reach, for example, if it’s connected to a projector and fixed to a ceiling, the
dongle must be set to remote connection mode. You can then connect to the dongle
using a PIN code. The PIN code is shown by the projector or HDTV once screen
mirroring is turned on in your Android™ device.
To switch operating modes
1
Unplug the charger cable from your Miracast™ Wireless Display.
2
Press and hold down the Connect button.
3
While keeping the Connect button pressed, plug the charger cable into the
micro USB port of the Miracast™ Wireless display.
4
Release the Connect button. After you release the button, the mode switches.
Starting screen mirroring when the dongle is out of reach
Your Miracast™ Wireless Display comes with an NFC tag, which you can scan to
start screen mirroring instead of scanning the NFC area of your Miracast™ Wireless
Display.
7
This is an Internet version of this publication. © Print only for private use.