Draft User guide Mono Bluetooth® Headset MBH20
Contents Introduction....................................................................................3 Function overview..............................................................................3 Accessory overview...........................................................................3 Basics.............................................................................................4 Charging the handset........................................................................
Introduction Function overview With the Mono Bluetooth® Headset, you can control incoming and outgoing phone calls while you listen to music from your device. You can connect your Bluetooth® headset to two Bluetooth® devices at the same time so that you can receive calls from two devices without having to disconnect and reconnect. Accessory overview 1. Ear speaker cover 2. Ear speaker 3. Micro USB port 4. Microphone 5. Power key/Call key 6.
Basics Charging the handset Before using the Mono Bluetooth® Headset for the first time, you need to charge it for approximately 2.5 hours. Sony chargers are recommended. To charge the battery 1 2 Plug one end of the USB cable into the charger (or into the USB port of a computer). Plug the other end of the cable into the Micro USB port on your Mono Bluetooth® Headset. Turning the headset on and off • To turn on the headset Press and hold down the Power key until the notification light turns green.
Wearing instruction You can wear the headset on either the left or right ear. 5 This is an Internet version of this publication. © Print only for private use.
Using your headset Call handling • To answer a call with the headset When you hear an incoming call signal, press the Call key. • To end a call During an ongoing call, press the Call key. • To reject a call When you hear an incoming call signal, press and hold down the Call key. • To answer a second call When you hear an incoming call signal during an ongoing call, press the Call key. The ongoing call is put on hold.
Resetting the headset 1 2 To reset the headset Make sure the headset is turned off. Press and hold down the Power key for more than 8 seconds till the notification light turns green for the second time and starts flashing rapidly. 7 This is an Internet version of this publication. © Print only for private use.
Troubleshooting I cannot answer a second call • • Make sure that your calling device supports the Bluetooth® headset profile. Make sure that the correct calling device is selected. I cannot pair a second Bluetooth® device • Make sure that Multipoint mode is activated. The headset turns off automatically • If the headset beeps several times shortly or a red notification light starts flashing rapidly before turning off, the battery level is low. Charge the battery.
Legal information SonyMBH20 Prior to use, please read the Important information leaflet separately provided. This User guide is published by Sony Mobile Communications AB or its local affiliated company, without any warranty. Improvements and changes to this User guide necessitated by typographical errors, inaccuracies of current information, or improvements to programs and/or equipment, may be made by Sony Mobile Communications AB at any time and without notice.
• • • • Reorient or relocate the receiving antenna. Increase the separation between the equipment and receiver. Connect the equipment into an outlet on a circuit different from that to which the receiver is connected. Consult the dealer or an experienced radio/TV technician for help.
