User's Guide
Table Of Contents
- 1 Document status
- 2 Introduction
- 3 Hardware requirements
- 4 Interactions Overview
- 5 Incoming events Overview
- 6 Gesture interactions - Example of partner possibilities
- 7 Detailed interaction and event states
- 8 Setting up
- 9 Disconnect and reconnect
- 10 Power ON A1ll
- 11 Turning OFF and Factory data reset
- 12 OTA and DFU mode
- 13 Automatic logging of physical activities - an overview
- 14 Remote mode
- 15 Control mode
- 16 Heart rate measurements
- 17 Alarm
- 18 Incoming call
- 19 Notifications
- 20 Charging battery TBD!!
- 21 Xperia at hand features
- 22 Document history
UXP X
2014-12-05 30 / 55
IxD BlueprintUXC
CONFIDENTIAL
ASW237 ASW136 ASW102 ASW101
12 OTA and DFU mode
12.1 OTA sequence
600 ms 600 ms 600 ms
LED A
600 ms 600 ms 600 ms 600 ms 600 ms
Enter OTA Connection is established Transmission started Transmission completed Restart and enter bonding mode AHA connects to A1II
The different modes during a OTA sequence have the same LED
indication, constant white blinking. When the update is completed A1II
enters bonding mode and AHA can reconnect.
Firmware update shall not be possible if the battery level is too low,
A1II must then indicate this to AHA.
12.1.1 OTA sequence.