User's Guide
Table Of Contents
- 1 Document status
- 2 Introduction
- 3 Hardware requirements
- 4 Interactions Overview
- 5 Incoming events Overview
- 6 Gesture interactions - Example of partner possibilities
- 7 Detailed interaction and event states
- 8 Setting up
- 9 Disconnect and reconnect
- 10 Power ON A1ll
- 11 Turning OFF and Factory data reset
- 12 OTA and DFU mode
- 13 Automatic logging of physical activities - an overview
- 14 Remote mode
- 15 Control mode
- 16 Heart rate measurements
- 17 Alarm
- 18 Incoming call
- 19 Notifications
- 20 Charging battery TBD!!
- 21 Xperia at hand features
- 22 Document history
UXP X
2014-12-05 25 / 55
IxD BlueprintUXC
CONFIDENTIAL
ASW251 ASW173 ASW083 ASW065
8.6 General bonding and connecting through NFC: UI flow
A1ll modes after NFC touch
Initial state Action Result
A1ll OFF and has not been bonded and connected before NFC touch Power on and bonding
mode, the phone can
connect
A1ll OFF but has been bonded and connected before NFC touch Power on and
reconnectable from the
bonded phone
A1ll ON and in bonding mode NFC touch Connected by the new
phone that is now bonded
A1ll ON and connected NFC touch Open AHA
A1ll ON and disconnected but have been connected before NFC touch Reconnect (A1II advertises
for reconnection)
A1II ON or OFF but is bonded with another device NFC touch Nothing (an unbonded
phone might power on A1II
but should not connect)