User's Manual

154
Settings
Setting an access point additionally
1
From the Home screen,
u
[Settings]
u
[More]
u
[Mobile
networks]
u
[Access Point Names].
2
.
3
[Name]
u
Enter a name
u
[OK].
4
[APN]
u
Enter an access point
name
u
[OK].
5
Tap and enter all other
information required by your
network operator.
6
u
[Save].
❖
Information
･
Do not change the MCC/MNC when setting the APN.
If you change them to values other than the default
values (440/10), the set APN will not be displayed on
the APN screen. If the set APN is not displayed,
u
Tap [Reset to default] or , then set the APN
again.
Initializing an access point
1
From the Home screen,
u
[Settings]
u
[More]
u
[Mobile
networks]
u
[Access Point Names].
2
u
[Reset to default].
Use tethering function to enable the terminal
to use as modem to allow USB compatible
devices, wireless LAN devices or Bluetooth
devices to access the Internet.
❖
Information
･
If you want to use tethering, subscription to Packet
Pack/packet flat-rate service is strongly
recommended.
･
For details on usage charge, see the following
website.
https://www.nttdocomo.co.jp/english/
･
When the docomo nano UIM card is not inserted,
mobile data communication is disabled, or the
terminal is out of service area, USB tethering, Portable
Wi-Fi hotspot and Bluetooth tethering that use
mobile network are not available.
Using tethering function