User Manual
Table Of Contents
- Ivy Aya_00_Introduction
- Ivy Aya_01_Getting Started
- Ivy Aya_02_Basic Operations
- Ivy Aya_03_Handset Interface
- Ivy Aya_04_Phone
- Ivy Aya_05_Messaging & Internet
- Ivy Aya_06_Camera
- Ivy Aya_07_Full Seg/One Seg
- Ivy Aya_08_Useful Functions
- Ivy Aya_09_Connectivity
- Ivy Aya_10_Global Services
- Ivy Aya_11_Handset Settings
- Ivy Aya_12_For Assistance
- Ivy Aya_13_Safety Precautions
Troubleshooting
Œ
Check Here First
Check Here First
Check the following Q & A. If problem persists, visit your nearest a SoftBank Shop or contact
Customer Service General Information.
Hints
Q Handset freezes/operation is unstable
A Power on handset again. If you are unable to power off handset, Press & Hold
and Volume Up Key at the same time for approximately three seconds, and release
your finger after it vibrates three times. Power on handset again. Data that was being
edited is erased after handset is powered on again.
Q Operation is unstable after a new application was installed
A The newly installed application may be the cause. Uninstall the application in Safe
mode. See "Uninstalling Applications." To power on handset in Safe mode:
(Long Press) Touch & Hold Power off Check Display, OK
n After powering on in Safe mode, "Safe Mode" appears at lower left.
n After restarting in Safe mode, handset can be powered on as usual.
n Before powering on handset in Safe mode, it is recommended that you back up
important data.
n By powering on handset in Safe mode, added widgets may be deleted.
Q Cannot use phone, mail, or Internet
A Check whether you are where signal is weak or out of service area.
A Power on handset again.
A Is handset in Airplane mode? To check that Airplane mode is canceled:
In Home Screen, (Settings) More... Airplane mode ( )
A Is data communication disabled? To check that data communication is enabled:
In Home Screen, (Settings) More... Mobile networks Mobile data
traffic( )
A Is a disabled access point set? To reset to initial settings:
In Home Screen, (Settings) More... Mobile networks Access Point
Names Reset to default
3