User's Guide

39
Before Using the Terminal
When using Micro USB Cable 01 (optional) for
charging, do the following procedures.
For opening/closing microUSB jack cover, see
"To ensure water resistant/dust resistant"
(P.24, P.25).
1
Open the microUSB jack cover and
insert the microUSB plug of the
microUSB cable straight into the
microUSB jack of the terminal,
with the USB symbol ( ) facing
up.
2
Insert the USB plug of the
microUSB cable into a USB port of
a PC.
･
Notification LED lights on the terminal.
For the notification LED for charging,
see "Notification LED" (P.46).
･
When "PC Companion software" screen
appears on the terminal, tap [Skip].
･
When a screen for new hardware
detection etc. appears on the PC, select
"
キャンセル
(Cancel)".
3
When the charging is complete,
remove the USB plug of the
microUSB cable from the USB port
of the PC.
4
Remove the microUSB plug of the
microUSB cable evenly from the
terminal.
5
Close the microUSB jack cover,
firmly press it and make sure that
there are no gaps between the
terminal and cover.
❖
Note
･
Installation of an MTP driver to a PC is required when
charging the battery with a Microsoft Windows XP
PC, because "USB connection mode" (P.172) is set to
"Media transfer mode (MTP)" by default. Install
Windows Media Player 10 or later to install an MTP
driver.
･
If you connect the microUSB cable to the USB jack of
the terminal for charging etc. with the terminal
powered off, the terminal is powered on and
notification LED lights, though operations are not
available. Be careful not to connect with the
microUSB cable in a place where the use is
prohibited such as in an airplane or hospital.
･
Check the connecting direction to connect correctly.
Wrong connection may cause damage.
Charging with a PC