User's Manual
Table Of Contents
- Content
- Introduction
- Getting Started
- Installation
- Create a EDGE/GPRS or CSD Connection
- Create a Wireless LAN Connection
- Advanced Wireless LAN Features
- Wireless Manager Status Screen
- Start Using Wireless Manager
- Wireless Manager Telephony Settings Screen
- Wireless Manager SMS Messages Screen
- Wireless Manager Phone Book Screen
- Wireless Manager Online Services Screen
- Troubleshooting
- Additional Information
- Declaration of Conformity
- Appendix A - Connection Parameters
- Appendix B - Changing the GC89 Wireless LAN Adapter Properties
- Glossary
- Index
12 Installation
When the GC89 is not in use it is recommended that you store it in the protective carrier box
provided.
Important!
Do not insert the card into the laptop until you have installed the software from the CD-ROM.
Simply cancel the New Hardware wizard if the card is accidentally inserted prior to software
installation.
Installing the Software
1. Insert the GC89 CD-ROM in your CD drive.
After a few seconds a Sony Ericsson splash screen is displayed.
Note:
If the CD-ROM does not autorun, select Start Run and type D:\Setup.exe into the Run
dialog. (Where D is your CD drive.)
2. The Wireless Manager is installed in the same language as your Windows
®
installation, or
English if your Windows
®
language is not available. See Supported Languages on page 96 for
more details.
3. The InstallShield Wizard for Sony Ericsson Wireless Manager opens; follow the instructions on
screen. Installation will appear to pause around 65% whilst drivers are installed; do not cancel.
When installation is complete click Finish.
4. Insert the GC89. Make sure it is fully inserted.
5. After a few seconds, the New Hardware Wizard opens and installs the necessary drivers onto
your PC from the GC89 CD. The wizard may require you to locate a specific driver file. If this
happens, a dialog opens; click Browse and select one of the following:
EDGE/Wireless LAN PC Card
GC89