User's Manual

146 Control panel
Cable
Use Cable to set the cable connection mode and the connection
parameters used when communicating through your P900's
cable port.
• Set the cable connection mode. Please note that you must set
the mode to
Modem when using the P900 as a modem and
when using the DUN (Dialup Networking) Wizard.
• Set the baud rate, parity, number of stop bits, character length
and type of flow control required for the connection. When
connecting your P900 via the desk stand to a USB port on
your PC, use the following (default) settings:
Tip You can set the cable connection mode when the Flip is
closed by selecting
Applications > Connections >
Cable.
GSM Networks
This option lets you choose what network to use when roaming
outside of your operator’s area. Select whether you want to
search for a new network or use a preferred one. You can also
make a list of preferred networks.
•
Search mode – Select between automatic or manual search for
a network.
•
Select network – Tap the button to access a list of available
networks.
•
New search – Tap the button to search for available networks.
• Preferred list – Show the networks that your P900 will search
for when you are roaming outside of your home network.
Note Your operator may not allow you to access all available
networks.
To add a network to the preferred list
1. Tap
Add network .
2. Select a network from the displayed list.
3. Select a position in the Preferred list and tap
Done .
Infrared
Use this setting to control the state of the infrared port of your
P900.
Baud rate
460800
Parity
None
Stop bits
1
Character length
8
Flow control
CTS/RTS