User Manual
Table Of Contents
- Introduction to the Integrator's Manual
- Integrating the CM52 Module
- Recommended Circuitry
- Functional Description
- Hints for Integrating the Module
- Antenna Type
- Antenna Placement
- Possible Communication Disturbances
- Technical Data
Confidential
USERS MANUAL
10(42)
Document number Revision
4/198 17-LXE 108 566 Uen PA7
2.2.2 Heat-Sink Requirements
The application is required to provide a heat-sink for the 3W AMPS capabilities of the
CM52.
The application should be designed to provide a heat sink with a thermal resistance of
4.0
o
C/W.
For applications that disable the 3W mode (Class I) and only operate in 0.6W mode
(Class III) a heat-sink is not required.
2.2.3 Mounting Holes
Mounting holes and tabs are provided for proper mechanical support of the CM52
module in the customer’s application. OEM application must provide sufficient
mechanical retention using the mounting holes and/or tabs or some other means. The
system connector and RF connector connections should not be used as a means of
mechanical support. Also, please note that the mounting holes may not substitute for
the actual grounding pins provided via the system connector.