User's Manual

LZT 123 1836 49
5.9.2.1 Power On Timing
Figure 5.9-2 Power On timing using PON_L as an example
The GS64 power On sequence is shown above using PON_L as an example. The
significant signals are VCC, P_ON and VREF, shown by solid lines. The other signals
(in dashed lines) are internal to the module and are shown for reference purposes
only.
Initially, power is supplied to the VCC pins. The presence of power raises the PON_L
through a pull-up resistor to VCC potential. In order to power the module, PON_L is
pulled to ground. Once PON_L has been held low for 125ms (denoted by t
1
) the
primary LDOs power up, including the VREF output. VREF exceeds it’s reset threshold
approx 500µs later, then 250ms afterwards (denoted by t
2
) the RESET line goes high.
The microprocessor can latch the power-on state by setting the power keep
(PWR_KEEP) high after the RESET goes high and before the power on (PON_L) signal is
released.
It is recommended that P_ON is held low for at least 450ms to guarantee completion
of the power up sequence.