User's Manual

LZT 123 1834 34
1
- These signals are required if the external SIM interface is used
2
- These pin connections are required for sleep mode operation
3, 4
- At least one of these interfaces is required to be connected
5.2 Dealing with Unused pins
Integrators applications may connect all of the GR64 signals pins, or just those
necessary for minimal operation, or most commonly some other permutation. If
GR64 signal pins are not connected to the host application you should terminate
them in the following manner.
Table 5.2-1 Unused Pin Termination
Pin Name Unused pin termination
1, 3, 5, 7, 9 VCC Must be connected
2, 4, 6, 8, 10, 12 GND Must be connected
11 CHG_IN Leave Open
13 ADIN4/GPIO5 Ground
14 ON/OFF Must be connected
15 SIMVCC Leave Open
16 SIMDET Leave Open
17 SIMRST Leave Open
18 SIMDAT Leave Open
19 SIMCLK Leave Open
20 DAC Leave Open
21 GPIO1 Connect to VREF
22 GPIO2 Connect to VREF
23 GPIO3 Connect to VREF
24 GPIO4 Connect to VREF
25 VRTC Leave Open
26 ADIN1 Ground
27 ADIN2 Ground
28 ADIN3 Ground
29 SDA Leave Open
30 SCL Leave Open
NOTE