User's Manual

32
Calling
To answer a call using voice
commands
When the phone rings, say “Answer” and the call is
connected.
To reject a call using voice
commands
When the phone rings, say “Busy”. The call is
rejected. The caller is diverted to voicemail, if
activated, or hears a busy tone.
Editing your voice commands
You can edit all your voice commands saved in
Contacts. Select the contact you want to edit a
voice command for } More } Edit contact. Scroll to
the relevant tab and edit your voice command.
To re-record a voice command
1 } Settings } the General tab } Voice control }
Voice dialling } Edit names.
2 Select a voice command } More } Replace
voice.
3 Wait for the tone and say the command.
Tips when recording and using voice
commands
If your phone cannot detect your voice command,
one of the following might have happened:
• You spoke too softly – try speaking louder.
• You held the phone too far away – hold it as you
do during a call.
• The voice command was too short – it should be
around one second long and more than one
syllable.
• You spoke too late or too soon – speak
immediately after the tone.
• You did not record the voice command when the
handsfree was attached – for voice control with a
handsfree kit, record when the handsfree is
attached.
• You used another intonation – use the same
intonation as in the recorded voice command.
Diverting calls
If you cannot answer incoming calls, you can divert
them to another number, for example, your
answering service.
When the Restrict calls function is activated, some
Divert calls options are not available.
Yui_UG_R1A.book Page 32 Tuesday, June 14, 2005 11:19 AM