User's Manual

Getting started

Draft for Internal Use Only - PA2

1 Connect the charger to the phone. The symbol

on the charger plug must face upwards.

2 It may take up to 30 minutes before the battery

icon appears on the screen.

3 Wait approximately 4 hours or until the battery

icon indicates that the battery is fully charged.

If you do not see the battery icon after this

time, press a key to activate the screen.

4 Remove the charger by pulling it straight out.

PIN (Personal Identity Number)

You may need a PIN (Personal Identity Number) to

activate the services in your phone. The PIN is

associated with your SmartChip, and not with the

phone. Your PIN is provided by your network

operator. When you enter your PIN, each digit

appears as *, unless your PIN starts with the same

digits as an emergency number, for example 112 or

911. This is so that you can see and call an

emergency number without entering a PIN.

If you make a mistake while entering your PIN,

delete the number by pressing .

Turning on the phone and

making calls

Make sure that the phone is charged and your

SmartChip is inserted before you turn it on. When

you have turned the phone on, you can use the

setup wizard to quickly and easily prepare your

phone for use.

Some functions use more battery power than others

and may cause a need for more frequent re-charging.

However, talk-time or standby time may become

noticeably shorter due to wear and you may have to

replace your battery. Only use approved batteries

from Sony Ericsson % 94 Battery Use and Care.

If you enter the wrong PIN three times in a row, the

SmartChip is blocked and the message PIN blocked

appears. To unblock it, you need to enter your PUK

(Personal Unblocking Key), % 83 SmartChip lock.